Product Code: RROSD
Availability: In Stock
$12.90
Ex Tax: $12.90

Feature:

-Thick copper and wide power routing to handle the most demanding power setup

-Dimension 36mm x 36mm (30.5mm x 30.5mm mounting holes)

-Built-in power distribution regulators to handle 3S-6S

-Built in multi stages power filter for Video Transmitter and Camera with pre-installed

and conveniently located connectors

-12V&3A and 5V&3A output: can be used for FPV cam and accessories

-NTSC and PAL can be easily selected using the onboard button

-Plug and Play (PnP) OSD information: Flight pack voltage, current draw, total current

consumption, RSSI, flight timer, Lap counter&timer

-Maximum motor current 160A total

-Automatic flight timer shows actual flight time

-The additional lost model buzzer sounds off 5 minutes after the quad has crashed.

-RSSI detection (FRsky ppm and analog compatible) displays in percentage

-Auto Battery alarm blinks the battery voltage when pack voltage hits the low limit

-Low RSSI turns on Buzzer (very handy to locate a downed quad)

-Onscreen menu allows user to calibrate pack voltage reading, current calibration, rssi

input, battery alarm level…etc....

-Lap Timer onscreen counter

-Lost model Siren (optional Buzzer)

 

Package Included:

1 X  Power Distribution Board

 

FAQ:

Change Video Mode(NTSC/PAL)

Hold down the Button for 10 seconds upon powering up the RROSD Pro. The LED will flash 5 times

to indicate that the Video mode has been successfully changed

 

Menu Operation

1.To enter into the menu of the OSD, power up the board and hold down on the button on

The OSD Pro board within 3 seconds of powering up. Keep it depressed until the menu

appears in your view then release.

To navigate through the menu single click the button to move down an option. Long press to

select an option

 

2.RSSI Calibration: To calibrate your RSSI reading, select the high reading with your radio and

receiver powered on and nearby. Flip off the radio and select the low reading to calibrate the

bottom signal range. *The reading you will see on the OSD is the true received strength of the

signal (more accurate and different from a 2 way telemetry signal being sent from a receiver)

 

3.Voltage Calibration: This menu item lets you calibrate your voltage reading by entering your

own offset.

 

4.Current Calibration: This menu item lets you calibrate your Current reading offset from -20%

to +20%

 

5.Set mAH Alarm: Allows you to set mAh consumption alarm. This will cause the respective

indicator to blink on screen when the desired value is reached. We recommend setting mAH

to 80% of the battery capacity

 

6.Enable Background Shade: Allows you to enable or disable the darkened bar behind the OSD

text for readability under intense sunlight

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: